Filter
Top Products
210
Chapter 10 Solving Problems
Incorrect or no Beep Codes
If the system operates normally, but there was no beep, the speaker may be
defective. Verify that the speaker is enabled by running the SCU. For
information about running the SCU, see Chapter 3, "Configuring The
System." If the speaker is enabled, but not functioning, contact your service
representative or authorized dealer for assistance.
Record the beep code emitted by POST, and refer to "Error and
Informational Messages" on page 213 for information about beep codes and
error messages.
Diskette Drive Activity Light Does Not Light
Check the following:
❑ Are the diskette drive power and signal cables properly installed?
❑ Are all relevant switches and jumpers on the diskette drive set
correctly?
❑ Is the diskette drive properly configured?
❑ Is the diskette drive activity light always on? If so, the signal cable may
be plugged in incorrectly.
If you are using the onboard diskette controller, use the SCU to make sure
that "Onboard Floppy" is set to "Enabled." If you are using an add-in
diskette controller, make sure that "Onboard Floppy" is set to "Disabled."
For information about running the SCU, see Chapter 3, "Configuring The
System."
If the problem persists, there may be a problem with the diskette drive,
system board, or drive signal cable. Contact your service representative or
authorized dealer for assistance.