Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
F-63 F-63
INVERTEC STT
SWITCH BOARD REPLACEMENT (continued)
ELECTRIC SHOCK can kill.
• With input power ON, there
are high voltages in the
machine. Do not reach
into the machine or touch
any internal part.
8. With the machine connected for 440/460 volt
operation and the proper input voltage
applied, turn on input power to the machine.
9. With the output free of a load, check open cir-
cuit voltages of the output. Voltage should be
85 VDC maximum.
10. Remove input power. Then remove the
5-amp fuses from the input supply fuse hold-
ers.
11. Install 20-amp fuses and test under load.
NOTE: A resistive-type grid load bank is recom-
mended.
14. Perform Retest After Repair.
WARNING