Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
F-71 F-71
INVERTEC STT
17. Remove the two 7/16” hex bolts that hold the
capacitor to the switch board. See Figure
F.36.
18. Loosen the set screw of the capacitor clamp
ring and remove the capacitor from the clamp
ring. See Figure F.37.
FIGURE F.36 – REMOVING CAPACITOR NUTS
CAPACITOR REMOVAL AND REPLACEMENT PROCEDURE (continued)
17. Remove the two 7/16” hex bolts that hold the
capacitor to the switch board. See Figure
F.36.
18. Loosen the set screw of the capacitor clamp
ring and remove the capacitor from the clamp
ring. See Figure F.37.
FIGURE F.37 – LOOSENING THE CLAMP RING SET SCREW