Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
F-36 F-36
INVERTEC STT
Apply Positive Apply Negative
Test Probe to Test Probe to
Terminal Terminal Test Result Conclusion Repair Action Next Procedure Notes
12 401/403 Greater than OK None Continue
1K ohm
Less than Shorted Replace both Snubber Test
100 ohms switch boards
401/403 12 Less than OK None Continue
100 ohms
Greater than Open Replace both Snubber Test
1K ohm switch boards
9 402/404 Less than OK None Continue
100 ohms
Greater than Open Replace both Snubber Test
1K ohm switch boards
402/404 9 Greater than OK None Continue
1K ohm
Less than Shorted Replace both Snubber Test
100 ohms switch boards
SWITCH BOARD TEST (continued)
NOTE: K ohm = ohm reading multiplied by 1000.
NOTE: Always make sure that switch boards are changed in matched pairs. Never mix an old style (different
part number) switch board with a new switch board (new part number).
TABLE F.5 – SWITCH BOARD RESISTANCE TEST (continued)
8. Reconnect all wiring harness leads (401/403,
1/8, 9, 12, 4/5, 402/404) to the switch board.
9. Install the case wraparound cover.