Filter
Top Products
C Commands Summary
106 MiLLennium Command Descriptions Manual
SEND
This command is used to send ASCII printable data from the COM1 or COM2 or disk file to a specified
communications port. This is a one-time command, therefore the data message must be preceded by the
SEND
command followed by the <Enter> key (<CR><LF>) each time you wish to send data. (Remember to use the
MESSAGES command to disable error reporting whenever two GPSCards are connected together via the COM ports.)
Syntax:
Scenario
: Assume that you are operating GPSCards as reference and remote stations. It could also be assumed
that the reference station is unattended but operational and you wish to control it from the remote station. From
the remote station, you could establish the data link and command the reference station GPSCard to send
differential corrections.
Figure C-4 Using SEND Command
SEND to-port data
Syntax Range Value Description
SEND Command
to-port COM1, COM2 Port option
data up to 100 characters ASCII data
COM 1
COM1
$PVAA data log...
se
n
d
c
o
m
1
l
o
g
c
o
m
1
p
v
a
a
o
n
t
i
m
e
5
Host PC - Reference
(Operational with position fixed)
Host PC - Rover
Rover station is commanding Reference
to send PVAA differential logs
Serial Cables
messages com1 off
send com1 log com1 pvaa ontime 5
COM 2
COM 2