Filter
Top Products
the receiver is in the standby mode.
[155] Troubleshooting Tuner
The FM reception is poor.
Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM
antennas (aerial) as shown below.
Receiver
Outdoor FM antenna (aerial)
[156] Troubleshooting Tuner
The FM stereo reception is poor.
Set FM mode to monaural.
[157] Troubleshooting Tuner
You cannot tune to radio stations.
Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials)
and connect an external antenna (aerial) if necessary.
The signal of the stations is too weak with automatic tuning. Use direct tuning.
Make sure you set the tuning scale correctly (when tuning to AM stations with direct
tuning).
No stations have been preset or the preset stations have been cleared (when tuning by
scanning preset stations is used). Preset the stations.
Press DISPLAY repeatedly on the receiver so that the frequency appears on the display