Filter
Top Products
OUT jacks.
Note
You can only configure this setting only when [HDMI Out B Mode] is set to [Zone2].
When a video device (projector, etc.) is connected to the ZONE 2 HDMI OUT jack, sound
may not be output from the receiver. In this case, set [Zone2 Audio Out] to [AMP].
When a TV which does not support audio content protection is connected to the HDMI
OUT B jack, specific audio may not be output from the receiver. In this case, set [Zone2
Audio Out] to [AMP].
When [Zone2 Audio Out] is set to [Zone2 TV + AMP] or [AMP], audio signals will be
downmixed. The following restrictions apply to downmixing.
Audio signals are not output to zone 2 when receiving a DSD signal.
If you change the sound field or speaker settings in the main zone while the input for zone 2 is set
to SOURCE or the same input is selected in the main zone and zone 2, the sound may also be
momentarily interrupted in zone 2.
The D.L.L. function does not work in the main zone.
The volume level of sound from ZONE 2 SPEAKER OUT terminals and HDMI OUT B jack may be
different from sound that is not downmixed.
No sound will be output to zone 2 if you play a DTS-CD with different HDMI inputs
selected in the main zone and zone 2.
You cannot remedy the time gap between video output on the TV connected to HDMI
OUT B jack and audio output from the speaker connected to ZONE 2 SPEAKER OUT
terminals using the A/V Sync function.
[43] Using the Multi-Zone Features
Enjoying sound in two rooms (multi-zone feature
using the receiver and another amplifier)
Setting the priority for the main zone (Priority)
Lets you set the priority when you select the same input for both the main zone and zone 2.
1. Select [Setup] - [HDMI Setup] from the home menu.
2. Set [Priority].
Main & Zone2:
You can enjoy the same input in the main zone and zone 2. However, there may be
some interference in the audio and video signals in the main zone and zone 2.
Main Only:
You can enjoy good audio and video quality in the main zone. There is no output in
zone 2.