Sony STR-ZA3000ES/STR-ZA2000ES/STR- ZA1000ES Marine Radio User Manual


 
Note
The following settings are required for this connection.
Set [HDMI Out B Mode] in the HDMI Setup menu to [Zone2]
Set [Zone2 Audio Out] in the HDMI Setup menu to [Zone2 AMP]
When outputting optical/coaxial audio signals, set the audio output to PCM on the
connected device. For details, refer to the operating instructions of the connected device.
Connecting another amplifier using the ZONE 3 AUDIO OUT jack
Speakers
Other amplifier/receiver
Audio cable (not supplied)
Note
Only devices connected to the analog audio input jacks and the built-in tuner (FM/AM)
can output signals to Zone 3. No signals are output from devices connected to only the
digital input jacks.
[19] Preparation
Connecting to the network
System requirements for a wired LAN connection
The following system environment is required to use the network function of the receiver via
a wired LAN connection.
Router
Use a router compatible with transmission speeds of 100 Mbps or greater.
We recommend that you use a router equipped with a built-in DHCP (Dynamic Host
Configuration Protocol) server because the default setting on the receiver is DHCP.