Filter
Top Products
Monaural audio cable (not supplied)
Speaker cable (not supplied)
*1
If you connect a subwoofer with an auto standby function, turn off this function when watching
movies. If the auto standby function is turned on, it switches to standby mode automatically based
on the level of the input signal to the subwoofer, and the sound may not be output.
*2
Notes on connections to the SPEAKERS SURROUND BACK/FRONT HIGH/FRONT B/BI-
AMP/ZONE 2 terminals
If connecting only one surround back speaker, connect it to the L (+/-) terminals.
If you have an additional front speaker system, connect it to these terminals. In this case,
perform the following procedure:
1. Select [Speaker Pattern] in the Speaker Setup menu, then select a speaker pattern
that does not have surround back and front high speakers.
2. Set [SB Speaker Assign] in the Speaker Setup menu to [Front B].
You can select the front speaker system you want by using the SPEAKERS button on the
receiver.
You can connect the front speakers to this terminal using a bi-amplifier connection. In this
case, set [SB Speaker Assign] in the Speaker Setup menu to [Bi-Amp].
Note
After you have installed and connected your speakers, be sure to select the speaker
pattern you want using [Speaker Pattern] in the Speaker Setup menu.
[11] Preparation
Installing and connecting speakers
Connecting the speakers in zone 2
You can enjoy sound from a device connected to the receiver in a zone other than the main
zone. For example, you can watch a DVD in the main zone and listen to a CD in zone 2.
Connect each speaker as illustrated below.
Be sure to disconnect the AC power cord (mains lead) before connecting cables. For details
on how to connect speaker cables to the receiver, see “How to connect speaker cables.”