Sony STR-ZA3000ES/STR-ZA2000ES/STR- ZA1000ES Marine Radio User Manual


 
using the receiver with 2 pairs of speakers)
Setting the speakers for zone 2
When the speakers in zone 2 are connected to the SPEAKERS SURROUND BACK/FRONT
HIGH/FRONT B/BI-AMP/ZONE 2 terminals of the receiver, configure the settings so that the
sound selected in zone 2 is output from the speakers connected to the SPEAKERS
SURROUND BACK/FRONT HIGH/FRONT B/BI-AMP/ZONE 2 terminals.
1. Select [Setup] - [Speaker Setup] from the home menu.
2. Select [Speaker Pattern].
3. Set a speaker pattern without surround back and front high speakers.
4. Select [SB Speaker Assign] - [Zone2].
Note
If a speaker pattern with surround back speakers or front high speakers is set, you cannot
set the SPEAKERS SURROUND BACK/FRONT HIGH/FRONT B/BI-AMP/ZONE 2
terminals for a bi-amplifier connection or a zone 2 connection.
[39] Using the Multi-Zone Features
Enjoying sound in two rooms (multi-zone feature
using the receiver with 2 pairs of speakers)
Enjoying sound in zone 2/3
You can enjoy sound from the receiver in zone 2 or zone 3 by the following procedure.
1. Turn on the amplifier in zone 2 or zone 3.
In the case of “Connecting the speakers in zone 2,” skip this step.
2. Press ZONE2 or ZONE3.
The power in zone 2 or zone 3 turns on and output is enabled in zone 2 or zone 3.
3. Press one of the input buttons to select the source signals you want to output.
4. Adjust to a suitable volume.
In the case of “Connecting the speakers in zone 2,” adjust the volume using
MASTER VOLUME on the receiver while [ZONE2 INPUT - xxx (input name)] is
shown on the display panel.
In the case of “Connecting another amplifier in zone 2/3,” adjust the volume using