Filter
Top Products
Reference Manual
00809-0100-2230, Rev BB
August 2014
Rosemount 2230
C-14
Appendix C. FOUNDATION fieldbus Block Information
19 FSTATE_VAL2 The preset analog value to use when failure
occurs in IN_2. Ignored if the “Fault state to value
2” in the MO_OPTS parameter is false.
20 FSTATE_VAL3 The preset analog value to use when failure
occurs in IN_3. Ignored if the “Fault state to value
3” in the MO_OPTS parameter is false.
21 FSTATE_VAL4 The preset analog value to use when failure
occurs in IN_4. Ignored if the “Fault state to value
4” in the MO_OPTS parameter is false.
22 FSTATE_VAL5 The preset analog value to use when failure
occurs in IN_5. Ignored if the “Fault state to value
5” in the MO_OPTS parameter is false.
23 FSTATE_VAL6 The preset analog value to use when failure
occurs in IN_6. Ignored if the “Fault state to value
6” in the MO_OPTS parameter is false.
24 FSTATE_VAL7 The preset analog value to use when failure
occurs in IN_7. Ignored if the “Fault state to value
7” in the MO_OPTS parameter is false.
25 FSTATE_VAL8 The preset analog value to use when failure
occurs in IN_8. Ignored if the “Fault state to value
8” in the MO_OPTS parameter is false.
26 FSTATE_STATUS Shows which points are in fault state.
27 UPDATE_EVT This alert is generated by any change to the
static data.
28 BLOCK_ALM The block alarm is used for all configuration,
hardware, connection failure or system problems
in the block. The cause of the alert is entered in
the subcode field. The first alert to become active
will set the Active status in the Status parameter.
As soon as the Unreported status is cleared by
the alert reporting task, another block alert may
be reported without clearing the Active status, if
the subcode has changed.