Filter
Top Products
Reference Manual
00809-0100-2230, Rev BB
August 2014
4-11
Rosemount 2230
Section 4. Configuration and Operation
4.6.1 Variables In the Select Variables menu
(1)
, you can choose which variables to present in
View Mode. The following options are available:
• Tank Pos 1-10
(2)
lets you configure a common set of variables to be
presented for all tanks
• Tk Pos 1, 2, 3... lets you configure variables individually for each tank
For a list of available variables see Table 4-1 on page 4-12.
Select Variables Menu
The Select Variables menu allows you to select variables to be displayed in
View Mode. Option “Tank Pos 1-10” can be used to specify a common set of
variables to be used for all tanks connected to the same 2410 Tank Hub. In
addition to this you can configure tanks individually by specifying a unique set
of variables for each tank. Note that the individual configuration will be added
to the configuration that is common for all tanks.
For a list of selectable variables, see Table 4-1 on page 4-12.
To select variables:
1. In View Mode, press <Menu> <Options> <Variables>.
Figure 4-17. The Select
Variables menu
2. Use the up and down arrow softkeys to navigate to the desired Tank
Position item.
3. Press the <OK> softkey to continue to the Selected Variables list.
Figure 4-18. The Select
Variables Custom option
4. In the Select Variables list, choose the variables you wish to show in
View Mode.
5. When finished, press <OK> to return to View Mode.
(1) Not available in Foundation fieldbus systems
(2) Tank Position refers to the position in the tank database for the 2410 Tank Hub.