Filter
Top Products
22
RUN AND OPERATION
3
Checks prior to test run
3 RUN AND OPERATION
3.1 Checks prior to test run
Installation check
Check that the inverter is installed correctly in a correct place. (Refer to page 6.)
Wiring check
Check that wiring is correct. (Refer to page 7.)
3.2 Basic operation (Speed setting, run, speed meter adjustment)
3.2.1 Setting the speed and running the motor
(1) Choosing PU operation mode (operation from the operation panel (FR-DU04
-1
)) and run-
ning at 150r/min
REMARKS
• The operation speed can be changed by changing the preset speed during operation following the steps 2 and 3 above.
• For monitor display changes by , refer to page 27.
• To select the PU operation mode in Pr.79 "operation mode selection", set "1" in the parameter. Refer to page 52 for details.
2.
4.
3.
1.
MODE
SET
MODE
FWD
REV
STOP
RESET
ON
FR-DU04
-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
FR-DU04
-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
FWD
REV
FR-DU04
-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
FR-DU04
-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
Power on Operation mode check
Running speed setting
Set the running speed to 150r/min.
Start
Press or .
The motor starts. The mode is automatically switched
to the monitoring mode and the output speed is displayed.
Stop
Press .
The motor is decelerated to a stop.
Display
Operation
The external operation mode (EXT) is selected when
switching power on with factory setting.
First, press to choose the speed setting mode.
Then, press to change the setting, and press
to write the value.)
(or)
(or)
Make sure that the operation command indication "PU" is lit.
If it does not appear, press to choose the operation
mode, and press to choose the PU operation mode.
When the desired result is not obtained, set the PU operation
mode in Pr.79.
MODE