Filter
Top Products
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for
the names. Command names can have a maximum of 30 characters. If you exceed the
maximum character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this
limitation.
On Microsoft Windows, you must put a backslash (\) before and after the name in addition to other
delimiters. For example, the following name is used in a command running under a Windows
operating system:
[\"Engineering"\]
For Linux, and when used in a script file, the name appears as the following:
["Engineering"]
When you enter the World Wide Identifier (WWID) of an HBA host port, some usages require
quotation marks around the WWID. In other uses, you must put angle brackets (< >) around the
WWID. The description of the WWID parameter tells you if you must put quotation marks or angle
brackets around the WWID.
• Script commands must end with a semicolon (;). You can enter more than one script command on
the command line each time you enter a CLI command.
Firmware Compatibility Levels
The supported RAID controller firmware for SMcli commands is 7.70.xx.xx, and later.
NOTE:
Modular Disk Storage Manager (MDSM) is backward compatible. When the latest Resource DVD is used to
install MDSM, all SMcli commands will work with the supported controller firmware.
Commands Listed By Function
This section presents the commands organized into groups related to physical, logical, and operational
features of the storage array.
Disk Group Commands
Create Disk Group
Delete Disk Group
Enable Disk Group Security
Resume Snapshot Rollback
Set Disk Group
Troubleshooting
Show Disk Group
Show Disk Group Export Dependencies
124