Filter
Top Products
Parameter Description
performanceMonitorInterval
The frequency of gathering performance data.
Enter an integer value for the polling interval, in
seconds, for which you want to capture data. The
range of values is 3 to 3600 seconds. The default
value is 5 seconds.
performanceMonitorIterations
The number of samples to capture. Enter an
integer value. The range of values for samples
captured is 1 to 3600. The default value is 5.
Additional Information
When you use this command, you can specify one or more of the optional parameters.
Passwords are stored on each storage array in a management domain. If a password was not previously
set, you do not need a password. The password can be any combination of alphanumeric characters with
a maximum of 30 characters. (You can define a storage array password by using the set storageArray
command.)
The polling interval and the number of iterations that you specify remain in effect until you end the
session. After you end the session, the polling interval and the number of iterations return to their default
values.
Set Snapshot Group Attributes
Description
This command defines the properties for a snapshot group.
Syntax
set snapGroup ["snapGroupName"] (userLabel="snapGroupName" |
repositoryFullPolicy=(failBaseWrites | purgeSnapImages) |
repositoryFullLimit=percentValue |autoDeleteLimit=numberOfSnapImages |
rollbackPriority=(lowest | low | medium | high | highest))
Parameters
Parameter Description
snapGroup
The alphanumeric identifier (including - and _) of
the snapshot group for which you are setting
properties. Enclose the snapshot group name in
double quotation marks (" ") inside of square
brackets ([ ]).
userLabel
The new alphanumeric identifier (including - and _)
that you want to give to the snapshot group. Use
this parameter when you want to rename the
snapshot group. Enclose the new snapshot group
name in double quotation marks (" ").
310