Filter
Top Products
Syntax
create snmpTrapDestination trapReceiverIP=ipAddress
communityName="communityName"
[sendAuthenticationFailureTraps=(TRUE | FALSE)]
Parameters
Parameter Description
trapReceiverIP The IP address of the SNMP manager to which you
want to send trap messages.
communityName The name of the SNMP community for which you
want to send trap messages.
sendAuthenticationFailureTraps This parameter turns on or turns off sending
authentication failure messages to an SNMP
manager. To send authentication failure messages,
set the parameter to TRUE. To prevent sending
authentication failure messages, set the parameter
to FALSE. The default is FALSE.
Reinitialize Thin Virtual Disk
Description
This command re-initializes a thin virtual disk.
NOTE: Formatting a virtual disk starts a long-running operation that cannot be stopped.
Syntax
start virtualDisk [virtualDiskName] initialize
[existingRepositoryLabel=existingRepositoryName]
[diskPool=diskPoolName capacity=capacityValue] [retainRepositoryMembers=(TRUE|
FALSE)]
Parameters
Parameter Description
virtualDisk
The name of the virtual disk for which you are
starting the formatting. Enclose the virtual disk
name in square brackets ([ ]). If the virtual disk
name has special characters, you also must
enclose the virtual disk name in double quotation
marks (" ").
existingRepositoryLabel
Causes the repository virtual disk to be replaced by
the candidate virtual disk specified.
• The value specified is an existing repository
virtual disk user label. The virtual disk specified
246