Filter
Top Products
NOTE: Starting with firmware 8.10, some RAID controller modules no longer support the
writeOrder parameter and the writeMode parameter.
Syntax
set remoteReplication (localVirtualDisk [virtualDiskName] |
localVirtualDisks [virtualDiskName1 ... virtualDiskNameN])
[role=(primary | secondary)]
[syncPriority=(highest | high | medium | low | lowest)]
[autoResync=(enabled | disabled)]
[writeOrder=(preserved | notPreserved)]
[writeMode=(synchronous | asynchronous)] [force=(TRUE | FALSE)]
Parameters
Parameter Description
localVirtualDisk The name local virtual disk for which you want to
define properties. Enclose the primary virtual disk
name in square brackets ([ ]). If the primary virtual
disk name has special characters or numbers, you
must enclose the primary virtual disk name in
double quotation marks (" ") inside square brackets.
localVirtualDisks The names of several local virtual disks for which
you want to define properties. Enter the names
virtual disks using these rules:
• Enclose all names in square brackets ([ ]).
• Separate each names with a space.
If the virtual disk names have special characters or
consist only of numbers, enter the names using
these rules:
• Enclose all names in square brackets ([ ]).
• Enclose each names in double quotation marks
(" ").
• Separate each names with a space.
role The setting for the local virtual disk to act as the
primary virtual disk or the secondary virtual disk. To
define the virtual disk as the primary virtual disk, set
this parameter to primary. To define the virtual
disk as the secondary virtual disk, set this
parameter to secondary. This parameter applies
only when the virtual disk is part of a replication
relationship.
syncPriority The priority that full synchronization has relative to
host I/O activity. Valid values are highest, high,
medium, low, or lowest.
autoResync The settings for automatic resynchronization
between the primary virtual disks and the
304