Filter
Top Products
Parameter Description
syncInterval
Specify the length of time between automatically
sending updates of modified data from the local
storage array to the remote storage array. You can
specify the length of time in minutes, hours, or
days.
warningSyncThreshold
Specify the length of time to wait until a warning is
triggered for cases in which the synchronization of
all of the virtual disks within the remote replication
group takes longer than the defined time. You can
specify the length of time in minutes, hours, or
days.
warningRecoveryThreshold
Specify the length of time to wait until a warning is
triggered when the automatic data update for the
point-in-time image on the remote storage array is
older than the defined time. Define the threshold
from the end of the previous update. You can
specify the length of time in minutes, hours, or
days.
NOTE: You must set the Recovery Point
Threshold to be twice as large as the
synchronization interval threshold.
warningThresholdPercent
Specify the length of time to wait until a warning is
triggered when the capacity of a replication
repository virtual disk reaches the defined
percentage. Define the threshold by percentage
(%) of the capacity remaining.
autoResync
The settings for automatic resynchronization
between the primary virtual disks and the
secondary virtual disks of a remote replicated pair
within a remote replication group. This parameter
has these values:
• enabled—Automatic resynchronization is
turned on. You do not need to do anything
further to resynchronize the primary virtual disk
and the secondary virtual disk.
• disabled—Automatic resynchronization is
turned off. To resynchronize the primary virtual
disk and the secondary virtual disk, you must
run the
resume remoteReplicationGroup
command.
Notes
• The Remote Replication premium feature must be enabled and activated on the local and remote
storage arrays that will be used for replication activities.
• You can use any combination of alphanumeric characters, hyphens, and underscores for the names.
Names can have a maximum of 30 characters.
186