Filter
Top Products
NOTE: Use the chapSecret parameter only for initiators requiring mutual authentication.
Set iSCSI Target Properties
Description
This command defines properties for an iSCSI target.
Syntax
set iscsiTarget [“iscsiID”]
(authenticationMethod=(none | chap) |
chapSecret=”securityKey” |
targetAlias=”userLabel”)
Parameters
Parameter Description
iscsiTarget
The iSCSI target for which you want to set
properties. Enclose the name in double quotation
marks (“ ”). You must also enclose the iscsi ID in
either square brackets ([ ]) or angle brackets (< >).
authenticationMethod
The means of authenticating your iSCSI session.
chapSecret
The password that you want to use to authenticate
a peer connection.
targetAlias
The name that you want to use for the target.
NOTE: Challenge Handshake Authentication Protocol (CHAP) is a protocol that authenticates the
peer of a connection. CHAP is based upon the peers sharing a “secret.” A secret is a security key that
is similar to a password.
NOTE: Use the chapSecret parameter only for initiators requiring mutual authentication.
NOTE: The targetAlias is a descriptive name that you can give to the target to help make it
easier to identify. You can use any combination of alphanumeric characters, hyphens, and
underscores for the targetAlias. The targetAlias can have a maximum of 30 characters.
Set Physical Disk Channel Status
Description
This command defines how the physical disk channel performs.
Syntax
set physicalDiskChannel [(1 | 2)]
status=(optimal | degraded)
297