Parameters
Parameter Description
controller
RAID controller module with the NVSRAM values to
save. Valid RAID controller module identifier values
are 0 and 1. The identifier value is 0 for the RAID
controller module on the top and 1 for the RAID
controller module on the bottom when viewed
from the rear of the enclosure. You must put
brackets ([ ]) around the RAID controller module
identifier.
file
Name of the file in which to save the values. You
must put quotation marks (" ") around the file
name.
Save Remote Replication Group Statistics
Description
This command saves to a file the synchronization statistics for one or more member virtual disks in a
remote replication group. The statistics collected are available only for remote replication group member
virtual disks in a primary role on the local storage array.
A set of data is collected during the synchronization process that can be used to evaluate how well the
replication configuration is functioning. The data is collected as a set of samples. A sample is created at
the beginning of a synchronization process and updated regularly while the synchronization process
proceeds.
A sample collects data until the synchronization process completes or until a disruption to the
synchronization process occurs such as a virtual disk ownership transfer or a read-write error. When a
synchronization process disruption is resolved (for example, the virtual disk is transferred to the alternate
RAID controller module), a new sample is created and updated as the synchronization process continues.
Syntax
save storageArray arvmStats asyncRemoteReplicationGroup
["
asyncRemoteReplicationGroupName"]
arvmStats file="filename"
[virtualDisk="virtualDiskName"
sampleType=(all | mostRecent | longestSyncTime | errors)
recordLimit=(1-90)]
Parameters
Parameter Description
asyncRemoteReplicationGroup
The name of the remote replication group for
which you are retrieving synchronization statistics.
Enclose the remote replication group name in
square brackets ([ ]). If the remote replication
272