Filter
Top Products
Parameter Description
• A four digit numerical identifier that you assign
to the repository virtual disk name.
Enclose the name of the existing repository virtual
disk in double quotation marks (" ").
If you want to create a new repository virtual disk
when you run this command you must enter the
name of either a a disk group or a disk pool in
which you want the repository virtual disk.
Optionally, you also can define the capacity of the
repository virtual disk. If you want to define the
capacity you can use these values:
• An integer value that represents a percentage
of the base virtual disk capacity.
• A decimal fraction value that represents a
percentage of the base virtual disk capacity.
• A specific size for the repository virtual disk.
Size is defined in units of bytes, KB, MB, GB, or
TB.
If you do not use the capacity option, the MD
storage management software sets the capacity to
20 percent of the base virtual disk capacity.
Enclose the name of the new repository virtual disk
in parenthesis ( ).
role
Use this parameter to promote the remote
replication group to a primary role or demote the
remote replication group to a secondary role. To
define the remote replication group as the primary
role, set this parameter to primary. To define the
remote replication group as the secondary role, set
this parameter to secondary.
force
The role reversal is forced if the communications
link between the storage arrays is down and
promotion or demotion on the local side results in
a dual-primary condition or a dual-secondary
condition. To force a role reversal, set this
parameter to TRUE. The default value is FALSE.
NOTE: Use the force parameter only when
using the role parameter.
nosync
This parameter defines whether to perform an
initial synchronization between the primary remote
replication group and the secondary remote
replication group before a role reversal operation is
performed. To perform an initial synchronization,
set this parameter to TRUE. The default value is
FALSE.
308