Filter
Top Products
Chapter 4 Parameters| BLD-E1 Series
Revision May 2009, 00DE, V0.50 4-91
‘0’
Exception code
‘2’
‘7’ LRC CHK Low
LRC CHK High
‘7’
CR END 1
END 0
LF
The explanation of exception codes:
Exception
code
Explanation
01
Illegal function code:
The function code received in the command message is not
available for the brushless DC motor drive.
02
Illegal data address:
The data address received in the command message is not
available for the brushless DC motor drive.
03
Illegal data value:
The data value received in the command message is not available
for the brushless DC motor drive.
04
Slave device failure:
The brushless DC motor drive is unable to perform the requested
action.
10
Communication time-out:
If Pr.09-03 is not equal to 0.0, Pr.09-02=0~1, and there is no
communication on the bus during the Time Out detection period (set
by Pr.09-03), “cE10” will be shown on the keypad.
09-05
Response Delay Time
Control
mode
VF VFPG FOCPM
Factory Setting: 2.0
Settings 0.0 ~ 200.0 ms
This parameter is the response delay time after AC drive receives communication command
as shown in the following.
PC or PLC command
Handling time
of the AC drive
Response Delay Time
Response Message
of the AC Drive
RS-485 BUS