Filter
Top Products
Chapter 4 Parameters| BLD-E1 Series
Revision May 2009, 00DE, V0.50 4-51
Settings Functions Descriptions
8
The 1
st
, 2
nd
acceleration
or deceleration time
selection
9
The 3
rd
, 4
th
acceleration
or deceleration time
selection
The acceleration/deceleration time of the drive could
be selected from this function or the digital statuses of
the terminals; there are 4 acceleration/deceleration
speeds in total for selection.
Bit 0 Bit
1
Descriptions
0 0 First acceleration/deceleration
time
When output frequency is less
than Pr.01-23 (Switch
Frequency between 1st/4th
Accel/decel), it will output 4
th
accel/decel time.
0 1 2
nd
accel./decel. time
1 0 3
rd
accel./decel. time
1 1 4
th
accel./decel. time
If the drive receives STOP command, it will decelerate
to stop by Pr.01-31.
10 EF Input
External fault input terminal and decelerates by Pr.07-
28. (EF fault will be recorded)
11 Reserved
12 Stop output
When this function is enabled, the drive output will stop
immediately and the motor is free run. When this
function is disabled, the drive will accelerate to the
frequency setting.
13-14 Reserved
15
Operation speed
command form VR
When the source of operation speed command is set to
VR, ACI and AVI at the same time and two or above
terminals are ON, the priority is VR>ACI>AVI.
When this function is enabled, the source of the
frequency will force to be VR.
16
Operation speed
command form ACI
When this function is enabled, the source of the
frequency will force to be ACI.
17
Operation speed
command form AVI
When this function is enabled, the source of the
frequency will force to be AVI.
18 Emergency Stop
When this function is enabled, the drive will ramp to stop
by Pr.07-28 setting.
19-26 Reserved