Filter
Top Products
System Initialization
Polycom, Inc. 21
2 Configure the following general settings:
General System Network Parameters
3 Click Add to add static routes. You need to enter the following information for each route:
Set Route Parameters
4 Click OK. The system restarts to apply your changes.
Enable ICMP V6 DAD Specify whether to enable Duplicate Address Detection (DAD) to ensure the IPv6
address set to the system is unique in the local network.
Enable ICMP Echo Specify whether to allow the system to respond to an ICMP (Internet Control
Message Protocol) echo request (Ping) sent from other devices in the network.
In some high-security environments, you may need to disable this option to protect
the system from Ping attacks.
MTU Specify the Maximum Transmission Unit (MTU) size.
LAN Speed Specify the speed or duplex modes for the LAN port. Select Auto to let the system
set the speed automatically.
Note: When setting the LAN port speed, contact your network administrator to
ensure that the switch link rate matches the system port speed.
NAT Public (WAN) Address Set the external IP address in Network Address Translation (NAT) environment.
NAT environments use private internal IP addresses for devices within the network,
while using one external IP address to allow devices outside the LAN to access
Capture Server Web Portal, view live streaming or VoD playback.
Parameter Description
Host Name Specify the host name of the system.
Domain Specify the domain name of the system.
Parameter Description
Destination Specify the IP address of the destination network.
Gateway Specify the IP address of the gateway to access the destination network.
Subnet Mask Specify the subnet mask for the destination network.