Filter
Top Products
System Configuration
Polycom, Inc. 30
3 Click OK.
Configure Port Settings
Port Settings allow specific ports in the firewall network environment to be allocated to multimedia calls.
To configure the port:
1 Go to Configuration > Port Settings.
2 Select Enable port configuration.
3 Configure the following settings:
Port Parameters
4 Click OK. The recording server restarts to apply your changes.
Set the System Time
You also can set the RealPresence Capture Server system time from the Admin Portal.
To set the system time:
1 Go to Configuration > System Time.
Outbound Proxy Server For communication with the SIP server when the system is configured on
the internal network, an outbound proxy server is required to implement
traversal of the firewall or NAT. In this case, you need to set the IP address
and port number for the outbound proxy server.
• Server Address: Enter an address of the SIP server.
• Server Port: Enter the port of the SIP server.
• If you need to configure both H.323 Gatekeeper parameters and SIP parameters
at the same time, click OK after you finish the configuration of both parameters.
• If the RealPresence Capture Server is registered to DMA as SIP server, you can
find Capture Server's information on DMA portal under Network > Endpoints.
Parameter Description
TCP Ports Specify the TCP port range.
You can set the starting port number (the default value is 10000), and the
ending port number is calculated automatically.
UDP Ports Specify the UDP port range. You can set the starting port number (the default
value is 20000), and the ending port number is calculated automatically.
Streaming Port Specify the streaming port range. The default value is 1640.
Multicast Port Specify the multicast port range. The default value is 1641.