Filter
Top Products
Appendix A – Console Commands
Polycom, Inc. 87
To configure DHCP IP Address for LAN 1 or LAN 2
1 Choose a network interface, click OK and type Enter.
2 Select
DHCP Address Setup, click OK and type Enter.
3 Click Set To DHCP.
4 The system will show the prompt message Yes to save the configuration. Choose Yes to proceed or
No to cancel.
5 Click Yes if you want the system to restart to apply your changes.
6 Choose DNS Server and type Enter to configure DNS server address for the system to resolve
domain names.
Disk Usage
Choose Disk Usage and type Enter to view the disk space usage of RealPresence Capture Server.
The total, used, and free disk space are shown.
Reset Console Password
This is to reset the console password, the system will show the prompt message to set new password to
access console.
Reset Portal Admin Password
This is to reset the Portal Admin password, the system will show the prompt message to set new password
to access the Admin Portal.
Reset Config
This is to reset the following system configurations to the default value:
● System Config
Call Settings
Signaling Settings
Port Settings
System time
Media Storage Settings
Multicast Settings
Certificate Management
QoS
SNMP
Active Directory
After you set the connection feature or IP address for the LAN interface, the system
must be restarted in order for the new settings to take effect.