Filter
Top Products
System Configuration
Polycom, Inc. 29
SIP
If your network supports SIP, you can use SIP to connect video calls. RealPresence Capture Server
supports SIP integration with SIP servers such as the Polycom DMA.
To configure the SIP settings:
1 Go to Configuration > Signaling Settings > SIP.
2 Configure the following settings:
SIP Parameters
System H.323 Alias Specify the H.323 alias for the system.
Remote Display Name Specify the name to be displayed to the far end.
Note: If you set the remote display name with dual-bytes characters like
Chinese, you will not see the characters on the far end endpoints in a
H.323 call between endpoints and the Capture Server system.
If the RealPresence Capture Server is registered to DMA as gatekeeper, you can
find Capture Server's information on DMA portal under Network > MCU > MCUs.
Parameter Description
Transport Type Specify the transport layer protocol used for communicating with the SIP
server. It needs to be consistent with the protocol supported by the SIP
server.
Enable Certificate Validation Specify whether to validate the server’s certificate before accepting it.
This option is available only after you select TLS as the Transport Type.
Note: RealPresence Capture Server always sends its own certificate to the
server, regardless of the selection here.
Register to SIP Server Specify whether to register the system to the SIP server.
SIP Server Type Choose a SIP server type from the dropdown list, currently only Generic
available.
SIP Server status Specify:
• Server Address
• Server Port
• Server Domain Name
Note: Never enter Capture Server IP for Server Address.
Register User’s Information Specify:
• User Name
• Auth User Name
• User Auth Password