1212 sFlow Commands
•
interfaces
— The list of interfaces to poll.
•
poll-interval
— The sFlow instance polling interval. A poll interval of 0
disables counter sampling. A value of
n
means once in
n
seconds a counter
sample is generated. (Range: 0–86400).
Default Configuration
There are no pollers configured by default.
The default poll interval is 0.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config)#sflow 1 polling ethernet 1/g1-1/g10
200
sflow polling (Interface Mode)
Use the sflow polling command in Interface Mode to enable a new sflow
poller instance for this data source if rcvr_idx is valid. Use the "no" form of
this command to reset poller parameters to the defaults.
Syntax
sflow
rcvr-index
polling
poll-interval
no sflow polling
•
rcvr-index
— The sFlow Receiver associated with the poller (Range: 1 - 8).
•
poll-interval
— The sFlow instance polling interval. A poll interval of 0
disables counter sampling. A value of n means once in n seconds a counter
sample is generated. (Range: 0 - 86400).
