Address Table Commands 231
Example
In this example, frame forwarding is enabled without learning, and with traps
sent every 100 seconds on port g1.
console(config)#interface ethernet 1/g1
console(config-if-1/g1)#port security forward trap
100
port security max
Use the port security max command in Interface Configuration mode to
configure the maximum addresses that can be learned on the port while the
port is in port security mode. To return to the system default, use the no form
of this command.
Syntax
port security max
max-addr
no port security max
• max-addr — The maximum number of addresses that can be learning on
the port. (Range: 0-100)
Default Configuration
The default value for this command is 100.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example shows using this command in Ethernet Interface
Configuration mode.
console(config-if-1/g3)# port security max 80
