598 VLAN Commands
no switchport general acceptable-frame-type tagged-only
Default Configuration
All frame types are accepted at ingress.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures 1/g8 to discard untagged frames at ingress.
console(config)#interface ethernet 1/g8
console(config-if-1/g8)#switchport general
acceptable-frame-type tagged-only
switchport general allowed vlan
Use the switchport general allowed vlan command in Interface
Configuration mode to add VLANs to or remove VLANs from a general port.
Syntax
switchport general allowed vlan add
vlan-list
[tagged | untagged]
switchport general allowed vlan remove
vlan-list
•
add
vlan-list
— List of VLAN IDs to add. Separate nonconsecutive VLAN
IDs with a comma and no spaces. Use a hyphen to designate a range of
IDs.
•
remove
vlan-list
— List of VLAN IDs to remove. Separate nonconsecutive
VLAN IDs with a comma and no spaces. Use a hyphen to designate a range
of IDs.
•
tagged
— Sets the port to transmit tagged packets for the VLANs. If the
port is added to a VLAN without specifying tagged or untagged, the
default is untagged.
