A SERVICE OF

logo

RADIUS Commands 525
source-ip
Use the source-ip command in Radius mode to specify the source IP address
to be used for communication with Radius servers. 0.0.0.0 is interpreted as a
request to use the IP address of the outgoing IP interface.
Syntax
source-ip
source
source —
A valid source IP address.
Default Configuration
The IP address is of the outgoing IP interface.
Command Mode
Radius mode
User Guidelines
User must enter the mode corresponding to a specific Radius server before
executing this command.
Example
The following example specifies 10.240.1.23 as the source IP address.
console(config)#radius-server host 192.143.120.123
console(config-radius)#source-ip 10.240.1.23
timeout
Use the timeout command in Radius mode to set the timeout value in
seconds for the designated Radius server.
Syntax
timeout
timeout
timeout —
Timeout value in seconds for the specified server. (Range: 1-30
seconds.)