726 IP Routing Commands
•
prefix-length
— Length of prefix. Must be preceded with a forward slash
(/). (Range: 0-32 bits)
•
nextHopRtr
— IP address of the next hop router.
•
preference
— Specifies the preference value, a.k.a. administrative distance,
of an individual static route. (Range: 1-255)
Default Configuration
Default value of preference is 1.
Command Mode
Global Configuration mode
User Guidelines
For the static routes to be visible, you must:
• Enable ip routing globally.
• Enable ip routing for the interface.
• Confirm that the associated link is also up.
Example
The following example identifies the
ip-address subnet-mask, next-hop-ip
and a preference value of 200.
console(config)#ip route 192.168.10.10 255.255.255.0
192.168.20.1 metric 200
ip route default
Use the ip route default command in Global Configuration mode to
configure the default route. Use the no form of the command to delete the
default route.
Syntax
ip route default
next-hop-ip
[
preference
]
no ip route default
next-hop-ip
[
preference
]
•
next-hop-ip
— IP address of the next hop router.
