352 IGMP Snooping Querier Commands
Syntax
ip igmp snooping querier version
number
no ip igmp snooping querier version
•
number
— IGMP version. (Range: 1–2)
Default Configuration
The querier version default is 2.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the IGMP version of the querier to 1.
ip igmp snooping querier version 1
show igmp snooping querier
This command displays IGMP Snooping Querier information. Configured
information is displayed whether or not IGMP Snooping Querier is enabled.
When the optional argument
vlan_id
is not used, the command shows the
following information:
• Admin Mode — Indicates whether or not IGMP Snooping Querier is
active on the switch.
• Admin Version — Indicates the version of IGMP that will be used while
sending out the queries.
• Source IP Address — Shows the IP address that is used in the IPv4 header
when sending out IGMP queries. It can be configured using the
appropriate command.
• Query Interval — Shows the amount of time in seconds that a Snooping
Querier waits before sending out the periodic general query
