VLAN Commands 609
existing command vlan protocol group <groupname> is updated to vlan
protocol group <groupid> so that groupid is used for both configuration
and script generation.
NOTE: If an attempt is made to migrate to the latest implementation with any of the
groupnames deleted prior to saving configuration on the pre 3.0.0.x code
(applicable only for platforms PC62xx, PCM622x, PCM8024), the problem on the
latest code will remain.
Syntax
vlan protocol group <
groupid
>
no vlan protocol group <
groupid
>
•
groupid
— The protocol-based VLAN group ID, to create a protocol-based
VLAN group. To see the created protocol groups, use the show port
protocol all command.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config)# vlan protocol group 1
vlan protocol group add protocol
Use the vlan protocol group add protocol command in Global Configuration
mode to add a protocol to the protocol-based VLAN groups identified by
groupid
. A group may have more than one protocol associated with it. Each
interface and protocol combination can be associated with one group only. If
adding a protocol to a group causes any conflicts with interfaces currently
associated with the group, this command fails and the protocol is not added
to the group.
