IP Routing Commands 739
IcmpInAddrMasks................................ 0
IcmpInAddrMaskReps............................. 0
IcmpOutMsgs.................................... 3
IcmpOutErrors.................................. 0
IcmpOutDestUnreachs............................ 0
IcmpOutTimeExcds............................... 0
IcmpOutParmProbs............................... 0
IcmpOutSrcQuenchs.............................. 0
IcmpOutRedirects............................... 0
IcmpOutEchoReps................................ 3
IcmpOutTimestamps.............................. 0
IcmpOutTimestampReps........................... 0
IcmpOutAddrMasks............................... 0
vlan routing
Use this command to enable routing on a VLAN. Use the “no” form of this
command to disable routing on a VLAN.
Syntax
vlan routing vlanid [index]
no vlan routing vlanid
vlanid — Valid VLAN ID (Range 1 – 4093).
index — Internal interface ID. This parameter is for NSF use only.
Default Configuration
Routing is not enabled on any VLANs by default.
Command Mode
VLAN Database mode
