488 QoS Commands
console#show class-map stop_http_class
Class Name........................... stop_http_class
Class Type........................... All
Class Layer3 Protocol................ ipv6
Match Criteria Values
---------------------------- -----------------------
Source IP Address 2001:DB8::/32
Source Layer 4 Port 80(http/www)
show classofservice dot1p-mapping
Use the show classofservice dot1p-mapping command in Privileged EXEC
mode to display the current Dot1p (802.1p) priority mapping to internal
traffic classes for a specific interface.
Syntax
show classofservice dot1p-mapping [<
unit>/<port-type><port>
|port-
channel
port-channel number
]
•
<unit>/<port-type><port>
— Specifies a valid unit/port combination:
–<
unit
> — Physical switch identifier within the stack. Values are
1-12
.
–<
port-type
> — Values are
g
for gigabit Ethernet port, or
xg
for 10
gigabit Ethernet port.
–<
port
> — port number. Values are
1-24
or
1-48
for port_type g, and
1-4 for port_type xg.
Example: xg2 is the 10 gigabit Ethernet port 2.
•
port-channel number
— Specifies a valid port-channel number. Range is 1-
8.
