Ethernet Configuration Commands 317
no speed
•
10
— Configures the port to 10 Mbps operation.
•
100
— Configures the port to 100 Mbps operation.
Default Configuration
This command has no default setting.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the speed operation of Ethernet port 1/g5
to force 100-Mbps operation.
console(config)#interface ethernet 1/g5
console(config-if-1/g5)#speed 100
storm-control broadcast
Use the storm-control broadcast command in Interface Configuration mode
to enable broadcast storm recovery mode for a specific interface. If the mode
is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast
traffic ingressing on an interface increases beyond the configured threshold,
the traffic will be dropped. Therefore, the rate of broadcast traffic will be
limited to the configured threshold.
Syntax
storm-control broadcast [level |
rate
]
no storm-control broadcast
• level— The configured rate as a percentage of link-speed.
•
rate
— The configured rate in kilobits per second (kbps). (Range: 0-100)
