Filter
Top Products
CPF180i and CPF300i Page 23
1. Press [Menu], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight
PORT 1 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select
AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
NOTE
If an AIS receiver is not connected, Port 1 Input can be connected to most DSC VHF’s for position
polling.
The Input and Output baud rate for each port is set using the Advanced Setup > In/Out Connections
menu For example if Port 1 is set for AIS38400, the Input and Output both operate at 38400 baud.
2.4.2 Connection Table For CPF300i
12VDC Power and NMEA PWR & ACC 1 Cable
Pin Wire Color Description Connection Example Additional Comments
1 Black Battery Ground &
Connect to Battery Ground and
Common for and signal ground
NMEA devices
2 Red Battery Positive Connect to Battery Positive
3 Green Port 3 Input Connect to Output of NMEA device Default is NMEA0183
4 Blue Port 1 Input Connect to Output of NMEA device Default is NMEA0183
5 Brown Port 1 Output Connect to Input of NMEA device Default is NMEA0183 with GGA, GLL, RMC,
XTE, DBT, DPT, MTW, VHW sentences
6 Gray Port 2 Input Connect to Output of NMEA device Default is NMEA0183
7 White Port 2 Output Connect to Input of NMEA device Default is NMEA0183 with GGA, GLL, RMC
and XTE sentences
8 Yellow Port 3 Output Connect to Output of NMEA device Default is NMEA0183 with APA, APB, BOD,
GGA, GLL, RMC and BOD sentences
2.4.3 Connection For CPF300i
2.4.3.1 DC Power Connection
CPF300i
Battery
10-35Vdc
Red
2A
Fuse
Black
Switch
+
-
Optional WAAS GPS
antenna
PWR & ACC 1 Cable
Transducer