Filter
Top Products
CPF180i and CPF300i Page 75
11. USER C-CARD
The optional User C-CARD is used to back up Marks, Routes, and Tracks stored in your
GPS Chart Plotter's memory. In the USA the User C-CARD is available directly from
Jeppesen Marine at 800/424-2627. The User C-CARD is similar to a back up disk used with
a PC, in case you have to clear the RAM to resolve an issue or load new software or if your
CPF180i and CPF300i becomes stolen, or if you would like to transfer Waypoint, Track and
Route information from one STANDARD HORIZON GPS Chart Plotter to another.
11.0 USER C-CARD MENU
This optional card is similar to using a floppy disk on a PC to backup your files or to transfer
the information that you have stored to a friends GPS Chart Plotter. The information shown
below will assist you to transfer the User Points, Routes and Track history to the optional
User C-CARD.
1
2
3
5
6
7
Type of data contained in the
file (Mark file, Waypoint file...)
File name
Number of Selected file
Information on stored User
Points on Internal Memory
Time of file creation
Date of file creation
5
6
2
1
3
7
SAVE LOAD DELETE FORMAT CHANGE
SLOT
1
FILE
1
MRKS
2
WPTS
5
RTES
1
TRKS
566
4
Number of selected Slot
4
Figure 11.0 - User C-CARD Menu
11.0.0 Formatting the User C-CARD
1. Press [MENU]. Move the ShuttlePoint knob to highlight USER POINTS and press [ENT].
2. Move the ShuttlePoint knob to highlight USER C-CARD and press [ENT].
3. Move the ShuttlePoint knob to highlight FORMAT and press [ENT].
4. A popup Warning window will to confirm you want to format the User C-CARD.
5. Select YES and press [ENT] to confirm (select NO otherwise). The format of User
C-CARD must be done before using a new User C-CARD: this operation prepares the
User C-CARD to receive and store information.
NOTE
Formatting permanently erases all files previously saved on the User C-CARD.
11.0.1 Transferring files to the optional User C-CARD
1. Remove a C-MAP BY JEPPESEN NT
+
/MAX C-CARD if present and insert the optional