Filter
Top Products
7. INITIAL SETTINGS
7-9
Auto rudder limit
Auto rudder limit determines the maximum rudder movement in degrees from the mid
position in the AUTO, NAV, Turn, FishHunter
TM
, Dodge and WIND modes. The value
set here should not be greater than the limit set for the rudder limit.
Complete the rudder limit setup before entering the auto rudder limit.
1. Select the current setting value for [Auto Rudder Limit] from the [Dockside Setup]
menu then push the Course control knob.
2. Rotate the Course control knob to set the rudder limit desired then push the knob
(setting range: 10° to max. rudder limit).
Manual rudder limit
In the remote (FU and NFU), FU dodge or NFU dodge modes, usually a wide range
of rudder angles are used, and therefore a larger number should be entered. however,
the setting must not exceed the rudder limit angle which is inherent on your boat.
Do not set the limit higher than the rudder limit. It is recommended to set the manual
rudder limit equal to or greater than the auto rudder limit. If the manual rudder limit is
set lower than the auto one, the rudder may be returned to center position too quickly
when the vessel is doing automatic turning by operation from the remote controller or
the dodge key.
Complete the rudder limit setup before entering the manual rudder limit.
1. Select the current setting value for [Manual Rudder Limit] from the [Dockside Set-
up] menu then push the Course control knob.
2. Rotate the Course control knob to set the rudder limit desired then push the knob
(setting range: 10° to max. rudder limit).