Filter
Top Products
7. INITIAL SETTINGS
7-11
4. Press any key to show the rudder test result.
• [Drive Unit]: Drive type used with the NAVpilot: [Reversible 12V (or 24V)], [Safe-
Helm 12V (or 24V)], or [Solenoid].
• [Rudder Deadband]: Rudder Deadband ([OK] or [Big])
• [Rudder Speed]: Rudder speed ([OK], [Fast], or [Slow])
Note: If the rudder deadband is higher than 1.3°, the boat can not be controlled
correctly. Check for air in the steering system and if the rudder speed is greater
than 10°/s.
5. Press the key to close the rudder test window.
7.4.2 Dockside setup for Fantum Feedback
TM
Drive unit setup
1. Select the current setting for [Drive Unit] from the [Dockside Setup] menu then
push the Course control knob.
2. Rotate the Course control knob to select the drive unit type then push the knob.
Setting option: [Reversible 24V], [Reversible 12V], [Safe-Helm 24V], [Safe-Helm
12V]
Push MENU key to Return
Drive Unit: Safe-Helm 12V
Rudder Deadband: OK
Rudder Speed: OK
Rudder Test
*: Displayed if Accu-Steer drive unit is selected.
Drive Unit: Safe-Helm 24V
Air Bleeding: No
Rudder Test: No
Helm Sensor Test*: No
Safe Helm/P.Assist Setup*
Dockside Setup