Filter
Top Products
7. INITIAL SETTINGS
7-41
7.13.1 How to select the source for nav data
Select the source of nav data to use in the NAV mode from the [NAV Option] menu.
1. Rotate the Course control knob to select [Nav Data Source] from the [NAV Op-
tion] menu then push the knob.
2. Rotate the Course control knob to select the current setting for [Data Source]
then push the knob.
3. Rotate the Course control knob to select data source then push the knob.
If you have more than one source of nav data, you can select [Both]. In this case,
the nav data fed by [Source2] is used when that of [Source1] is not available.
Note: If you have NavNet vx2 equipment connected and it is synchronized with
the NAVpilot ([NavNet2] turned on in the [NAV Option] menu, [Source2] is auto-
matically selected.
4. Rotate the Course control knob to select [Source1] then push the knob.
If you have some equipment which outputs nav data, the name appears in the win-
dow. In the example above, a NavNet3 equipment, with the unique number of
000C2F, is connected.
*: Not shown when [Boat Type] = [EVCS Boat].
5. Rotate the Course control knob to select source then push the knob.
6. If you have more than one device that outputs nav data, you can select it at
[Source2].
NAV Data Source
Data Source: Source1
Source1: PORT1
Source2: PORT2
Source1
Source2
Both
- - - - - - - - - - - - - -
NAVNET3: 000C2F
PORT2*