Filter
Top Products
7. INITIAL SETTINGS
7-26
7. Rotate the Course control knob to select [Select Output Sentence] then push the
knob.
One of the following displays appear depending on the NMEA output format se-
lected.
8. To turn a sentence ON or OFF, do the following;
Note: Turn OFF the sentence “RSA“ (rudder) in case of Fantum Feedback
TM
.
1) Rotate the Course control knob to select the sentence then push the knob.
2) Rotate the Course control knob to select [ON] or [OFF] then push the knob.
9. Press the key to return to the [NMEA0183 Port1] menu.
10. Rotate the Course control knob to select [Incoming NMEA0183 Data] then push
the knob.
This display shows the NMEA0183 sentences currently being received.
11. Press the key twice to return to the [NMEA0183 Port Setup] menu.
If you have equipment connected to the NMEA0183 port 2, set up the equipment
similar to how you set up the equipment in the NMEA0183 port 1.
Note: [Port2] is not shown when [Boat Type] is set to [EVCS boat].
Ver 3.0
DBT: OFF
GLL: OFF
HDT: OFF
RMB: OFF
RSA: OFF
ZDA: OFF
DPT: OFF
GNS: OFF
MTW: OFF
RMC: OFF
VHW: OFF
GGA: OFF
HDG: OFF
MWV: OFF
ROT: OFF
VTG: OFF
DBT: OFF
HDM: OFF
RMB: OFF
VHW: OFF
VWT: OFF
GLL: OFF
MTW: OFF
ROT: OFF
VWR: OFF
GGA: OFF
HDT: OFF
RMC: OFF
VTG: OFF
ZDA: OFF
Ver 1.5
DBT: OFF
GLL: OFF
MTW: OFF
RMC: OFF
VHW: OFF
GGA: OFF
HDT: OFF
RMB: OFF
RSA: OFF
ZDA: OFF
DPT: OFF
HDG: OFF
MWV: OFF
ROT: OFF
VTG: OFF
Ver 2.0
Incoming NMEA0183 Data
AAM
APB
BOD
BWC
BWR
DBT
DPT
GGA
GLL
GNS
HDG
HDM
HDT
MTW
MWV
RMB
RMC
ROT
THS
TLL
VHW
VTG
VWR
VWT
XTE
ZDA