Filter
Top Products
5. MAINTENANCE, TROUBLESHOOTING
5-7
5.3.9 Rudder test
The rudder test checks drive type, presence or absence of bypass/clutch circuit, etc.
Open the diagnostic test options window, select [Rudder Test] then push the Course
control knob.
Note: The rudder test is not available when [Boat Type] is set to [EVCS Boat].
When the rudder reference unit is installed
1. Open the diagnostic test options window, select [Rudder Test] then push the
Course control knob.
The message shown below appears.
2. Center the rudder then push the Course control knob.
During the test, the message shown below appears.
When the rudder test is completed, the message shown below appears.
Note: If the rudder test is not completed satisfactory, the steering mode can not
be changed from the STBY mode.
3. Press any key to show the test result.
For detail of the test result, see "The result of the rudder test" on page 5-10.
Use wheel to
center rudder before
rudder test.
Are you sure?
Yes
No
Testing Rudder-PLS Wait.
Push any key to abort
Rudder test completed.
Push any key to continue