Filter
Top Products
3. ALARMS
3-3
3.4 Watch Alarm
The watch alarm periodically warns the helmsman to check the NAVpilot when in the
AUTO or NAV mode.
1. Open the [Alarm] menu.
2. Rotate the Course control knob to select the current setting for [Watch Alarm]
then push the knob.
3. Rotate the Course control knob to select [OFF] or [ON] then push the knob. For
[OFF], go to step 6.
4. Rotate the Course control knob to select the current setting value for [Watch
Alarm] then push the knob.
5. Rotate the Course control knob to set the time interval then push the knob (set-
ting range: 1 to 99 min).
6. Press the key three times to close the menu.
If the set time passes without operation, the buzzer sounds and the message "The set
time has passed" appears. Further, if three minutes elapses after the watch alarm has
sounded, the alarm becomes louder. Press any key to stop the alarm.
3.5 Deviation Alarm
The deviation alarm sounds in the AUTO and NAV modes when the heading deviates
more than the deviation alarm value.
Note: The setting value of the deviation alarm can be changed, but you can not deac-
tivate this alarm.
1. Open the [Alarm] menu.
2. Rotate the Course control knob to select the current setting value for [Deviation
Alarm] then push the knob.
3. Rotate the Course control knob to set the degree of deviation then push the
knob.
4. Press the key three times to close the menu.