Furuno 711c Marine Instruments User Manual


 
APPENDIX 1 MENU TREE
AP-2
*
1
: Not Shown with Fantum Feedback
TM
.
*
2
: Not shown when [Boat Type] = [Sailboat] or in case of Fantum Feedback
TM
.
*
3
: For Fantum Feedback
TM
, only the [GO Straight] or [Orbit to STBD] are available.
*
4
: Cannot be set higher than [Rate of Turn] set on the [Ship’s Characteristics] menu.
*
5
: Shown when [Boat Type] = [Sailboat].
(Continued from previous page)
Parameter Setup
AUTO Option
NAV Option
Fish Hunter
Option*
2
WIND Option*
5
Sea State (Full-Auto, Semi-Auto, Manual-Calm,
Manual-Moderate, Manual-Rough)
Deviation Level (Auto, Level (1-9, 5))
Manual Parameter (See page AP-1 for settings.)
Trim Gain*
1
(Auto, Manual (1-20, 10))
Speed Calculation (Auto, Manual (0.1-99kn, 30.0kn))
Advanced AUTO (OFF, ON)
Net Towing AUTO*
2
(OFF, ON)
Cse After Remote*
1
(Previous Course, Present Course)
NAV Mode (Course, XTE(Precision), XTE(Economy))
NAV Data Source
Waypoint Switching (Auto, Manual)
After Arrival*
3
(GO Straight, Orbit to PORT, Orbit to STBD,
Figure Eight PORT, Figure Eight STBD,
Square PORT, Square STBD)
NavNet2 (OFF, ON)
Data Source (Source1, Source2, Both)
Source1 (Port1, Port2)
Source2 (Port1, Port2)
Circle (Rate of Turn*
4
, 1°-5°, 3°)
Orbit (Radius, 0.05-9.99NM, 0.05NM)
Spiral (Speed (0.1-2.0kn, 0.5kn); Radius (0.05-9.99NM, 0.05NM))
Figure8 (Radius, 0.05-9.99NM, 0.05NM))
Square Turn (Side Length (1.0-9.9NM, 1.0NM);
Azimuth (Auto, Manual, 0°-359°, 0°))
Zigzag
Turn Angle (30°-150°, 90°)
Termination (Number of Turns (1-20, 10);
DIistance (1-99NM, 50NM),
Continuous)
Mode Type (AWA, TWA)
Wind Tack Rud Angle (10-45°, 35°)
Wind Damping (OFF, ON (0.7-99.9sec, 5.0sec))
Fixed Tack Angle (15°-179°, 100°)
Rate of Slow Tack (1°-10°/s, 3°/s)
Rate of Fast Tack (10°-30°/s, 20°/s)
Tack Timer (OFF, ON (1-99sec, 10sec))
(Continued on next page)