Filter
Top Products
7. INITIAL SETTINGS
7-13
5. Release the key.
The message shown below appears.
6. Press the or key according to the direction of rudder movement found in
step 4.
The message shown below appears.
7. Turn the helm or press the or key hard-over to PORT/STBD then push
the knob.
The message shown below appears.
8. Long press the or key hard-over in the opposite direction from step 7.
While pressing a key, the message shown below appears.
9. When the rudder reaches the hard limit, release the or key to display the
following message.
10. If the rudder reached the hard limit, push the Course control knob. If not, press
the key then retry the rudder test.
After the test is completed, one of the following messages appear.
• Rudder Test completed. Push any key to continue.
• Rudder speed is too slow (fast) to control the vessel. The vessel may not be
controlled properly.
Which side did rudder
move to?
STBD side
Not Move/Abort
PORT side
Move rudder to PORT or
STBD hard limit by using
wheel or arrow key.
Move Rudder
Rudder at Hard limit
Abort
Push and hold arrow key
pressed to mode rudder
to oppsite hard limit.
Move to STBD
Abort
Move to PORT
Don’t release the key until
the rudder has reached the
hard limit!
Has the rudder reached
the hard limit?
NoYes