Filter
Top Products
7. INITIAL SETTINGS
7-23
7.5 CAN bus Port Setup
The [CAN Bus Setup] menu sets up the equipment connected to the CAN bus port. To
open the [CAN Bus Setup] menu, select [CAN Bus Setup] from the [Installation Menu]
window.
1. The cursor is selecting [Device List];
push the Course control knob.
The [Device List] display shows the
name of the CAN bus equipment con-
nected to the CAN bus port. In the example illustration, the FURUNO heading
sensor PG-700 is connected. The series of alphanumerics which follow the model
name are the CAN bus unique number.
2. To change the device name, do the following. If you do not need to change the
name, go to step 3.
1) Push the Course control knob.
2) Rotate the Course control knob to select character then push the knob.
3) The cursor moves to the next character. Repeat step 2 to change the charac-
ter. You can select the input location with the and keys. The name
can have a maximum of 14 characters.
3. Press the key to return to the [CAN Bus Setup] menu.
4. Rotate the Course control knob to select [Incoming CAN Bus data].
This display shows all the NMEA 2000 sentences that the NAVpilot is capable of
receiving. The Parameter Group Number (PGN) the NAVpilot is currently receiv-
ing are highlighted.
Device List
Incoming CAN Bus data
Select Output PGN List
Refresh: No
CAN Bus Setup
Device List
PG-700: 0019E4
126992
127488
129026
129285
130313
126464
127258
129025
129284
130312
126208
127251
128267
129283
130311
059904
126996
127489
129029
130306
130314
060928
127250
128259
129033
130310
130577
Incoming CAN Bus data