Filter
Top Products
BBV28581 05/2010 9
Steps for setting up (also refer to Quick Start)
1. Receive and inspect the drive
v Check that the part number printed on the label is the same as that on the
purchase order.
v Remove the Altivar from its packaging and check that it has not been damaged
in transit.
2. Check the line voltage
v Check that the line voltage is compatible with the voltage
range of the drive (page 11
).
3. Mount the drive
v Mount the drive in accordance with the instructions
in this document (page 13
).
v Install any options required.
Steps 2 to 4 must
be performed with
the power off.
4. Wire the drive
(page 20)
v Connect the motor, ensuring that its
connections correspond to the voltage.
v Connect the line supply, after making
sure that the power is off.
v Connect the control part.
5. Configure the drive (page 32)
v Apply input power to the drive but
do not give a run command.
v Set the motor parameters
(in Conf mode) only if the factory
configuration of the drive is not
suitable.
v Perform auto-tuning.
6. Start