Filter
Top Products
166 Multimeter Command Reference Chapter 3
Comments • Executable when Initiated: Yes
• Coupled Command: No
• *RST Condition: unaffected
• Power-On Condition: no bits are enabled
Example Enable Service Request on Message Available Bit
*SRE 16
Enable request on MAV.
*STB?
*STB? returns the value of the Status Byte Register. The RQS bit (bit 6 in the status
byte having decimal weight 64) is set if a service request is pending.
Comments • Executable when Initiated: Yes
• Coupled Command: No
• Related Commands: *SRE
• *RST Condition: none
*TST?
*TST? causes the HP E1312A and HP E1412A to execute its internal self-test and
returns a value indicating the results of the test.
A zero response indicates that the self-test passed. Any non-zero response indicates
that the test failed. Use the
SYST:ERR? command to read the error and description
from the error queue. Note the error number and description returned in the error
message. See Appendix B, “Error Messages”, for information on interpreting the
error number and description response(s).
The settings for all SCPI commands are unchanged by this command.
Comments • Executable when Initiated: No
• Coupled Command: No
• *RST Condition: none
*WAI
*WAI causes the HP E1312A and HP E1412A to wait for all pending operations to
complete before executing any further commands.
Comments • Executable when Initiated: Yes
• Coupled Command: No
• Related Commands: *OPC, *OPC?
• *RST Condition: none